Installation Instructions

INSTALLATION INSTRUCTIONS

1. Remove bolts "A" and "B" from each side of

the hopper assembly.

2. Loosen bolts "C" on the hopper assembly

until sides of the hopper can move freely in the

slots. Repeat on other side.

3. Position the Sand Seal (95-0112) in the

hopper and secure bottom with bolts "A".

4. Install bolt "B" but do not tighten. Push the

side of the hopper in against the edge of the

Sand Seal until there is no gap. Secure bolts

"B" and "C". Repeat on the other side.

5. Drill (2) holes through the hopper back with

a 9/32 inch drill bit. Use the punched holes in

the Sand Seal as a guide.

6. Install and secure bolts "D" through the top

two center holes of the Sand Seal as shown.

7. Position the Brace - Seal (95-0111)

underneath and behind the Sand Seal. Line up

the holes in the brace with the slots in the Sand

Seal and loosely assemble both parts. Push

the brace downward until it rests against the

inside flange of the Sand Seal and tighten the

bolts.

FORM NO. 95-0109

INSTALLATION

INSTRUCTIONS

PART NO. 95-0110

SAND SEAL KIT (2300 TOPDRESSER)

The TORO Company - 1995

PAGE 1
FORM NO. 95-0109 PART NO. 95-0110 INSTALLATION INSTRUCTIONS SAND SEAL KIT (2300 TOPDRESSER) INSTALLATION INSTRUCTIONS 1. Remove bolts "A" and "B" from each side of the hopper assembly. 2. Loosen bolts "C" on the hopper assembly until sides of the hopper can move freely in the slots. Repeat on other side. 3. Position the Sand Seal (95-0112) in the hopper and secure bottom with bolts "A". 4. Install bolt "B" but do not tighten.
PAGE 2
Use existing fasteners. Seal - Sand (95-0112) Brace - Seal (95-0111) Capscrew - Hex Hd. (4) (321-4) Lock Washer (2) (3253-3) Flat Washer (6) (3256-2) "C" "B" "C" Drill after installing Sand Seal. Flat Washer (6) (3256-2) "D" Capscrew - Hex Hd.