Installation Instructions



The T

oro Company – 1997

Printed in USA

FORM NO. 3319–584 Rev. B

INSTALLATION

INSTRUCTIONS

PART

NO. 95–4220

REAR ATTACH–A–MATIC HITCH

Loose

Parts

Note: Use the chart below to identify parts for assembly.

DESCRIPTION QTY. USE

Mounting bracket assembly

Mounting bracket

Lock nut .375–16

Carriage bolt .375–16 x 3.5”

Assemble Attach–A–Matic



Assembling

the Rear

Attach–A–Matic

Hitch

The rear Attach–A–Matic is mounted on the rear

axle of the tractor.

1. Push one bolt upward through the rear hole on

each side of the Attach–A–Matic, then through

a mounting bracket (Fig. 1).

m–3618

Figure 1

1. Attach–A–Matic

2. Facing

front of tractor

Facing rear of tractor

Mounting bracket

Carriage bolt .375 x 3.5”

Lock nut

7. Latch

2. Begin to thread a nut onto the end of the bolt

(Fig. 1).

PAGE 1
FORM NO. 3319–584 Rev. B REAR ATTACH–A–MATIC HITCH INSTALLATION INSTRUCTIONS PART NO. 95–4220 Loose Parts Note: Use the chart below to identify parts for assembly. DESCRIPTION QTY. Mounting bracket assembly 1 Mounting bracket 2 Lock nut .375–16 4 Carriage bolt .375–16 x 3.5” 4 USE Assemble Attach–A–Matic Assembling the Rear Attach–A–Matic Hitch 6 2 4 The rear Attach–A–Matic is mounted on the rear axle of the tractor. 1.
PAGE 2
Installation Instructions 3. 4. Place the Attach–A–Matic under the rear axle (Fig. 2), and rotate the mounting brackets over the top of the axle to hold the Attach–A–Matic in place. Push the remaining two bolts upward through the front holes on the Attach–A–Matic , then through the remaining holes on the mounting brackets. Thread a nut onto each bolt. 5. Tighten the nuts evenly on the bolts to hold the Attach–A–Matic in place. 6.