Operator's Manual

FORM NO. 3319–526

PART NO. 98–0798

INSTALLATION

INSTRUCTIONS

    

   

Loose Parts

Note: Use the chart below to identify parts used for assembly.

DESCRIPTION QTY. USE

Wheel bracket

Gage wheel assembly

Clevis pin 3/8 x 1” (25 mm)

Hairpin cotter 1-5/8” (41 mm)

Install left rear gage wheel

Parts Manual 1 Save for ordering replacement parts

Install Bracket

1. Remove mower, refer to: Operator’s Manual for

instructions.

2. Measure over 3-3/8” (86 mm) from left rear

mower bracket to locate wheel bracket (Fig. 1).

3. Hold wheel bracket flat with top of mower and

mark mounting location.

4. Remove paint from the wheel bracket and

mower areas that will be welded.

5. Weld wheel bracket to the left rear of the mower

(Fig. 1).

m–3231

Figure 1

1. Wheel bracket

2. 3-3/8” (86 mm)

3. Weld here X

PAGE 1
FORM NO. 3319–526 PART NO. 98–0798 INSTALLATION INSTRUCTIONS Loose Parts Note: Use the chart below to identify parts used for assembly. DESCRIPTION QTY. Wheel bracket 1 Gage wheel assembly 1 Clevis pin 3/8 x 1” (25 mm) 1 Hairpin cotter 1-5/8” (41 mm) 1 Parts Manual 1 USE Install left rear gage wheel Save for ordering replacement parts Install Bracket 1. Remove mower, refer to: Operator’s Manual for instructions. 2.
PAGE 2
Installation Install Gage Wheel Adjusting Gage Wheels 1. Slide gage wheel assembly into wheel bracket (Fig. 2). The gage wheels must be adjusted in the proper hole location for each height-of-cut position. 2. Select proper hole location for cut height and secure with 3/8 x 1” (26 mm) clevis pin and 1-5/8” (41 mm) hairpin cotter (Fig. 2). 1. After adjusting height-of-cut of the mower, adjust gage wheels. 2. Remove hairpin cotter and clevis pin to change hole location (Fig. 3). 3.