Installation Instructions

FORM NO. 3321-470

INSTALLATION

INSTRUCTIONS

PART NO. 99-0267

REMOTE OIL FILTER KIT

for OFZ TRACTION UNITS

Loose Parts

Note: Use the chart below to identify parts used for assembly.

DESCRIPTION QTY. USE

Filter adapter

O–ring

1/2” NPTF fitting

Oil hose

Install filter adapter and hoses

Remote filter Plate

Bolt 5/16–18 x 1” (26 mm)

Locknut 5/16–18

1/4” NPTF nipple

Remote filter adapter

Oil filter

Cable tie

Install remote oil filter

Parts Catalog 1 Save for ordering parts

Note: Coat all threads with pipe joint sealant

before assembly. Do not use teflon

tape.

Install Filter Adapter

1. Drain engine oil and remove existing oil filter

from engine. Refer to: traction unit Operator’s

Manual.

2. Clean engine oil filter mounting surface (Fig. 1).

3. Install O–ring into grove of filter adapter and

thread filter adapter onto engine oil filter

mounting until snug, then turn and additional

1/4 turn and orient as shown (Fig. 1).

m–3972

Figure 1

1. Oil filter mounting

2. O–ring

3. Filter adapter

PAGE 1
FORM NO. 3321-470 REMOTE OIL FILTER KIT for OFZ TRACTION UNITS INSTALLATION INSTRUCTIONS PART NO. 99-0267 Loose Parts Note: Use the chart below to identify parts used for assembly. DESCRIPTION QTY.
PAGE 2
Install Oil Hoses Install Remote Filter Adapter 1. Thread 1/2” NPTF fittings into filter adapter. 1. 2. Torque fittings to 90–130 in. lbs. (10–15 N•m) ending between 12 and 3 o’clock as shown (Fig. 2). Measure back 6-1/2” (165 mm) from left frame upright to front of plate. Center filter plate holes on flange width and clamp plate in position (Fig. 3). 2. 3. Thread fixed hose ends into 1/2” NPTF fitting (Fig. 2).
PAGE 3
4. Secure remote filter adapter to filter plate with (2) 5/16-18 x 1” (26 mm) bolts and (2) 5/16-18 flange locknuts (Fig. 4). 11. Apply a thin coat of oil to filter rubber seal and thread oil filter onto remote filter adapter until it is snug, then turn an additional 1/2 turn (Fig. 4). 5. Thread (2) 1/4” NPTF fittings into remote filter adapter. 12. Install drain plug and fill engine with oil. Refer to: traction unit Operator’s Manual. Note: 13. Run engine and check for oil leaks.
PAGE 4