’ PART NO. 99-0527 FORM NO. 99-0537 SET-UP AND PARTS CATALOG l STANDARD ELECTRIC SPRAY SYSTEM SOLENOID UPGRADE MOUNT KIT This kit is only for use on the following products: Multi-Rio 1100’s Standard Spray System Model #41122, 1608TH Skid Sprayer Model #41411, and Workman's Standard Spray Stern Model #41222. For parts and setup concerning the Multi-Pro 1100 and 061ST Skid Sprayer, refer to the contents starting on this page. For parts and setup concerning the Workman, refer to page four (4} in this manual.
8. Disconnect Control Valve from the Solenoid Assembly at 45° elbow. Remove and discard 45° elbow from outlet side of Control Valve. Save close nipple for later use, Installing New Valves: 9. Install three (3) 90° 3/4" Hose Barbs into the front outset ports {wiring side) of Solenoid Waives. See FIG. 2. 10. Install three (3) Throttling Waives into rear outlet ports of Solenoid Valve. Install Straight Hose Barbs removed in step 5 into Throttling Valves.
MULTI PRO 1100 & 061ST SKID SPRAYER Ref.| Part No. Description Qly. Ref, {Part No.
Workman Upgrade: NOTE: “Right”, “Left”, “Front”, and “Rear” are referenced while seated In the operator’s position. NOTE: Use “sealer” for all threaded fittings. "Sealer” refers to the Teflon Thread Tape. IMPORTANT! USE NEW SEALER ON ALL REUSED FITTINGS. 1. Remove electrical connections to Solenoid Assembly and Control Valve. FIG. 1 8. Boom Feeder Hose 8. Gauge Tube Fitting 7. Th rattling Valve 8. 45" Elbow 1. Bypass Hose 2. Bypass Manifold 3. Control Valve 4. Supply Hose 2.
Solenoid Mounting Bracket using three screws just installed. Secure Solenoids three (3) M6 hex nuts and lock washers. See . 3. 14, Install Solenoid Valve and Bracket Assembly to the Bottom Cross Support as shown in FIG. 2, Secure with two (2) flange cap screws and Hex Flange Nuts. NOTE: If the Hydroelectric 4000 kit (Model 09850} has been installed or will be installed, it is necessary to remove and discard top Cross Support Angle and put the Bottom Cross Support Angle in is place.
WORKMAN Fleece Part No. Description Qty. Heft Part No, Description Qty.
SOLENOID VALVE (99-0536) Ref Part No. Description Qty. No. Description Qty. 1 }959317 Coil Ass’y Nylon Encapsulated | 1 9 (42136 Spacer Stainless Steel 2 2 1t Spring Stainless Steel 1 10 ]93-1085 Hotly Polypropylene {black] 1 3 |95-0318 Armature Stainless Steel 1 11 192-1036 Stem Stainless Steel 1 4 195-9318 Retaining Ring Steel, Plated 1 12 182-0367 Lower Diaphragm Piston 8.8.
