Installation Instructions

FORM NO. 3321-567
INSTALLATION
INSTRUCTIONS
PART NO. 99-3716 and 99–3717
FUEL SHUT-OFF VALVE KIT
for GARDEN TRACTORS ONLY
Note: Use the following instructions only when installing these valves on Garden Tractors.
Install Fuel Shut–Off Valve
1. Drain fuel from tank into an approved container.
Refer to: tractor Operator’s Manual.
2. Loosen, but do not remove, screw clamp on tank
nipple (Fig. 2). Unscrew existing fuel valve and
discard (Fig. 1).
3. Clean and dry threads on new valve and in fuel
tank (Fig. 1).
4. Apply thread sealant to new fuel valve threads.
Use Permatex Aviation Form-A-Gasket #3H or
equivalent.
Note: Apply thread sealant sparingly and
only to threads.
5. Install new fuel valve and locate as shown, 20°
left from center of tractor (Fig. 1).
m–3985
3
2
1
Bottom View of Tank
Figure 1
1. Fuel tank
2. Fuel valve
3. 20° from center
6. Tighten screw clamp around tank nipple (Fig. 2).
7. Push fuel hose onto barbed end of fuel valve and
secure with hose clamp (Fig. 2).
m–3984
3
2
1
4
Figure 2
1. Screw clamp
2. Fuel valve
3. Fuel hose
4. Hose clamp