Installation Instructions

FORM NO. 3321-592

INSTALLATION

INSTRUCTIONS

PART NO. 99-3745

CHOKE AND THROTTLE CABLES KIT

Loose Parts

Note: Use the chart below to identify parts used for assembly.

DESCRIPTION QTY. USE

Adapter

Screw #10-32 x 1/2” (13 mm)

Throttle cable

Choke cable

Install replacement cables

Install Cables

1. Remove existing throttle and choke cables from

tractor (Fig. 1).

Note: Save all hardware for use when

installing new cables.

2. Observe location of boots on ends of new

throttle and choke cables. Remove boots.

3. Remove jam nut from new choke cable (Fig. 1).

4. Route throttle lever through rear of dash and

secure with screws previously removed. Press

knob onto throttle lever (Fig. 1).

5. Route choke cable through front of dash and

secure with jam nut previously removed (Fig. 1).

m–4024

Figure 1

1. Throttle

2. Knob

3. Choke

4. Jam nut

PAGE 1
FORM NO. 3321-592 CHOKE AND THROTTLE CABLES KIT PART NO. 99-3745 INSTALLATION INSTRUCTIONS Loose Parts Note: Use the chart below to identify parts used for assembly. DESCRIPTION QTY. Adapter 1 Screw #10-32 x 1/2” (13 mm) 1 Throttle cable 1 Choke cable 1 USE Install replacement cables Install Cables 1. 2 Remove existing throttle and choke cables from tractor (Fig. 1). Note: Save all hardware for use when installing new cables. 3 1 2.
PAGE 2
6. Align adapter so tabs are below engine cable bracket (Fig. 2). 7. Secure adapter to engine cable bracket with new #10-32 x 1/2” (13 mm) screw (Fig. 2). 12. To adjust cables, move throttle lever to the “FAST” position and pull the choke to the full “CHOKE” position. 13. Loosen clamp screw and push the cables up, at the adapter, until engine controls are against their stops (Fig. 3). 14. Tighten cable clamp mounting screw securely (Fig. 3). 2 1 m–4025 Figure 2 1. Adapter tab 2.