Installation Instructions

FORM NO. 3321–685
STRIPING KIT
FOR 44”/52” WAM DECKS
PART No. 99–4590
INSTALLATION
INSTRUCTIONS
Loose Parts
Note: Use the chart below to identify parts used for assembly.
DESCRIPTION QTY. USE
Mounting bracket
Wiper
Hex lock nut, 1/4–20
Hex head screw, 1/4–20 x 5/8” (16 mm)
Flat washer, 1/4”
Speed nut, 1/4”
Parts catalog
8
1
8
16
8
8
1
Installation of kit
Installation Instructions 1 Read before installing
Installation
1. 44” deck installation
A. Orient the wiper as shown in Fig. 1. From
the left hand end, count over to the seventh
set of holes. Measure 1-1/2 inches from the
center of these holes toward the right hand
end and make a mark. Cut and remove
excess material beyond this point.
3
4
1
2

5
Figure 1
1. Left hand end
2. Right hand end
3. 1st set of holes
4. Seventh set of holes
5. 1–1/2” measurement
B. Install the speed nuts on each of the
mounting brackets as shown in Fig. 2.
m–4049
1
2
Figure 2
1. 1/4–20 Speed nut 2. Mounting bracket
C. Attach the mounting brackets (with speed
nuts assembled) to holes 1,2,4,5,6 and 7
(Fig. 3) using the flat washers and 1/4–20 x
5/8” (16 mm) screws. Place the flat washers
on the screws and insert the screws through