Installation Instructions

FORM NO. 3322–120

44” 2–Stage Snowthrower Kit

PART

NO. 99–6492

ART NO. TR99D6492

INSTALLATION

INSTRUCTIONS

Loose

Parts

Note: Use the chart below to identify parts used for assembly.

DESCRIPTION QTY. USE

Lever assembly

Pivot bracket

Spring tension link

ension spring

Shoulder bolt

Bolt, 5/16 – 18 x 3/4”

Lock nut, 5/16 – 18

Installation of kit

Installation Instructions

Read before installing

Description

This kit is designed for use on 2–stage snowthrowers,

Model No.79366 and Model No. 99470 used on

Garden tractors, to improve the drive belt tension.

Installation

1. Release the belt tension lever to relieve belt

tension if mounted to a tractor.

2. Remove the tension spring, shoulder bolt,

tension lever and spring tension link (Fig. 1) and

discard.

POTENTIAL HAZARD

• Spring is under tension.

WHAT CAN HAPPEN

• Stored spring energy can cause personal

injury when r

eleased rapidly

HOW TO AV

OID THE HAZARD

• Carefully unhook spring with a firm grip

and r

elease slowly

PAGE 1
FORM NO. 3322–120 44” 2–Stage Snowthrower Kit INSTALLATION INSTRUCTIONS PART NO. 99–6492 PART NO. TR99D6492 Loose Parts Note: Use the chart below to identify parts used for assembly. DESCRIPTION QTY. Lever assembly 1 Pivot bracket 1 Spring tension link 1 Tension spring 1 Shoulder bolt 1 Bolt, 5/16 – 18 x 3/4” 1 Lock nut, 5/16 – 18 2 Installation Instructions 1 Description This kit is designed for use on 2–stage snowthrowers, Model No.79366 and Model No.
PAGE 2
2 1 m–4084 Figure 3 1 4 1. Spring tension link 3 5. Assemble the lever assembly to the pulley box frame by inserting the leg furthest from the bend into the frame where the old lever was located (Fig. 4). Insert the shoulder bolt, with the head to the inside through the pivot hole and on through the hole in the second leg. Place the pivot bracket over the threaded end. Install a 5/16” lock nut and tighten securely (Fig. 4). 6.
PAGE 3
7. Using the hole in the pivot bracket as a template drill a 11/32” hole in the pulley box leg (Fig. 5). Insert the 5/16 x 3/4” bolt in this hole. Install a 5/16” nut and tighten securely (Fig. 5). Installation Instructions 2 5 3 1 6 4 m-4085 Figure 5 1. Tension spring (6 7/8” lg.) 2. Pulley pivot arm 3. Shoulder bolt 8. 4. 5/16” lock nut 5. 5/16 x 3/4” bolt 6.