Installation Instructions

1
All Rights Reserved
Printed in the USA
 2002 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Suspension Seat Kit
100 and 200 Series Z Master

Part No. 99–8522
Form No. 3328–189
Installation Instructions
Loose Parts
Note: Use the chart below to identify parts for assembly.
DESCRIPTION QTY. USE
Suspension Seat
Spacer—2 holes for 200 Series
Spacer—3 holes for 100 Series
1
2
2
Installing the seat
Wire Harness
Plastic Ties
1
5
Installing the wire harness
Decal 1 Installing the decal
3,4
6
10
5
2
7
8
9
M-4310
1
Figure 1
1. Seat
2. New Wiring Harness
3. Spacer (2 holes for Z200
Series Models) (Shown)
4. Spacer (3 Holes for Z100
Series Models)
5. Plastic ties
6. Seat Track
7. Seat mounting frame
8. Slot
9. Adjustment lever
10. Vinyl curtain
Removing the Seat
1. Tip the seat forward and remove the screws holding the
seat cushion to the seat pan.
2. Remove the seat cushion and tip the seat mounting
frame back down.
3. Remove the nuts holding seat pan to the seat tracks and
carefully remove the seat including the conical spacers
and set aside (Fig. 1). Discard the conical spacers.
4. Remove the nuts holding the seat track to the seat
mounting frame. Keep the nuts and tracks for
installing the new seat (Fig. 1).