Installation Instructions

The Toro Company – 1999

Printed in USA

FORM NO. 3322-579 Rev A

INSTALLATION

INSTRUCTIONS

Part No. 99–8523

Lower Control Bar Kit

Loose Parts

Note: Use the chart below to identify parts for assembly.

DESCRIPTION QTY. USE

Lower Control Bar

Cotter Pins

Install Lower Control Bar

Removing Existing Lower

Control Bar

1. Remove the 2 clevis pins installed in existing

lower control bar. Remove push on washers after

clevis pins are removed. Discard the push on

washers (Fig.1).

2. Remove nut and bolt from upper control bar and

then remove the existing lower control bar

(Fig.1).

m–4433

Figure 1

1. Existing lower control bar

2. Clevis pin

3. Bolt

4. Nut

5. Push on washer

6. Upper control bar

PAGE 1
FORM NO. 3322-579 Rev A Lower Control Bar Kit INSTALLATION INSTRUCTIONS Part No. 99–8523 Loose Parts Note: Use the chart below to identify parts for assembly. DESCRIPTION QTY. Lower Control Bar 1 Cotter Pins 2 Removing Existing Lower Control Bar 1. 2. USE Install Lower Control Bar 6 1 3 Remove the 2 clevis pins installed in existing lower control bar. Remove push on washers after clevis pins are removed. Discard the push on washers (Fig.1).
PAGE 2
Installation Instructions Installing Lower Control Bar 1. Install the new lower control bar into the upper control bar and align it with holes in the handle (Fig. 2). 2. Install the new clevis pins through the handle and into the lower control bar. Align the holes in the clevis pins with the holes in the new lower control bar (Fig. 2). 3. Install the new cotter pins into aligned holes (Fig. 2). 4. Install the nut and bolt into the upper control bar and tighten securely (Fig. 2).