Installation Instructions

ManualsBrandsToro ManualsAttachments, Parts & AccessoriesToro 99-8576

FORM NO. 3322–197

Washout Port Cover Kit

PART

NO. 99–8576

ART NO. TR99D8576

INSTALLATION

INSTRUCTIONS

Loose

Parts

Note: Use the chart below to identify parts used for assembly.

DESCRIPTION QTY. USE

Cover–plate 1

Installation of kit

Installation Instructions

Read before installing

Description

This kit is designed for use with a 44” Vac–Bagger,

Model No.79305 and Model No. 716503006, used on

Garden Tractor 44” decks with a washout port (Serial

No. 9900001 and T9BB0001).

The washout port must be removed to install the

vac–bagger counterweight. This removal leaves open

holes in the top of the mower deck.

The cover plate included in this kit prevents debris

from being thrown out of the open holes in the

mower deck.

POTENTIAL HAZARD

• Open holes in the mower expose you and

others to thrown debris.

WHAT CAN HAPPEN

• Debris thrown out of holes in the mower

can cause injury.

HOW TO AV

OID THE HAZARD

• Never operate mower without hardware

mounted in all holes in mower.

• Install hardware in mounting holes when

the washout port is removed.

Installation

1. Remove the two bolts, flat washers and nuts

holding the washout port to the deck and remove

the washout port (Fig. 1). Save the washout port

and the bolts, nuts and washers for reinstallation

when removing the counterweight.

m–4330

Figure 1

1. Washout

port

1/4–20 nut (2)

1/4” flat washer (2)

1/4–20 x 3/4” (19 mm)

bolt (2)

Summary of content (2 pages)

PAGE 1
FORM NO. 3322–197 Washout Port Cover Kit INSTALLATION INSTRUCTIONS PART NO. 99–8576 PART NO. TR99D8576 Loose Parts Note: Use the chart below to identify parts used for assembly. DESCRIPTION QTY. USE Cover–plate 1 Installation of kit Installation Instructions 1 Read before installing Description Installation This kit is designed for use with a 44” Vac–Bagger, Model No.79305 and Model No. 716503006, used on Garden Tractor 44” decks with a washout port (Serial No. 9900001 and T9BB0001). 1.
PAGE 2
. Using one of the two bolts, washers and nuts from the washout port, install the cover plate to the deck (Fig. 2). Place the bolt up through the deck (head to underside of deck) in the hole closest to the rear of the deck. Install one end of the cover to the bolt and secure loosely with the nut and flat washer. IMPORTANT: Make certain to use washers under the heads of the two bolts, under the mower deck. 7. Tighten the rear bolt of the cover plate. 8.