User's Guide

Route the single cable from the mini-receiver up into the
controller. If this application is for temporary use only, you can
just swing open the front panel or remove the access cover on
the controller for cable entry because you will unplug the cord
and close or re-install the panel after the remote session.
Find the female socket for connection to the RJ jack on the
mini-receiver’s cord. On the early models of the MC-E “Blue”
and on the KwikDial controllers, use the CMR-ADP adapter to
convert the 5-pin connector on the controller to the socket for
the jack. (Later models of the MC-E “Blue” have the RJ
socket.) On the Rain Dial-R (and other blue-faced Rain Dials)
and the Total Control-R, the connection is on the swing out
face panel, just under the edge of the circuit board.
For permanent installations, the CL-MR mini-receivers and
CMR-ADP cable adapters are sold separately.
If needed, to put the receiver in a better location for
reception, lengthen the cord from the mini-Receiver to the
controller with extension cables (50’ or less). The cables and
RJ connections must have six (6) conductors. NEVER PLUG
THE REMOTE’S CORD INTO A TELEPHONE SYSTEM.
Diagram 2: Controller Connection Points
The Irritrol Rain Dial-R and Rain Dial “Blue” do not require
the adapter cable. The cord from the mini-receiver plugs
directly into the edge of the front panel.
5.
R-100-KIT, Remote Kit: After connecting the receiver, it is
time to set the PIN numbers in the transmitter and receiver. Set
the PIN you plan to use in the transmitter first.
Setting the PIN in the handheld transmitter:
Press the red “MODE” PWR button to turn on the
remote transmitter
Press the “Setup” button twice; “SET PIN” appears
Use the UP or Down arrow button the set the first digit
of the PIN number on the left
Use the Right Arrow button to move to the second digit
With the UP or Down arrow button set the second PIN
number
Repeat the steps to set the other numbers in your 4-digit
PIN
When the 4-digit PIN is set, press the “Enter” button to
save the PIN
To teach the new PIN to the mini-receiver, (not CLIMATE
LOGIC’s receiver)
Turn transmitter on with the red “MODE/PWR” button
Press the Setup button twice; “SET PIN” screen appears
with your PIN displayed
Hold down the only button on the mini-receiver for
more than 8 seconds.
When the green light on the receiver begins flashing
rapidly, release the receiver’s button (intermittent
flashing will continue) press the ENTER button on your
transmitter. The red light on the receiver will blink
briefly.
The receiver has now learned the new PIN and has
exited the “learn” mode.
10.