User's Guide

Introduction: When used with compatible irrigation systems,
the R-100-KIT remote control set and the CL-R1 individual
remote allow the user to activate watering zones with no need
to stand at the controller. For testing or troubleshooting the
system or providing supplemental watering, the user is free to
walk the landscape site, turning zones on and off.
The R-100-Kit remote set allows the user to plug its mini-
receiver unit into a variety of irrigation controllers to receive
and process the remote signal from the handheld transmitter.
The R-100-KIT remote kit from Irritrol
The CL-R1 individual, handheld remote transmitter is also
available, separately, as the compatible remote for Irritrol’s
CLIMATE LOGIC
®
wireless weather sensing system.
1.
To teach the transmitter the maximum number of
stations on the controller:
To save time using the remote, set the number of stations in
the transmitter to match the number of stations on the
controller. For example, for a 12- station controller, set the
transmitter to a station maximum of twelve also. If only
using 10 of the 12, set max to 10.
Press the SETUP button once to view the Max Station
screen. Leave the Max Station screen in the display.
Use either the UP or the DOWN button to set the
desired maximum station number.
With the desired number displayed, press ENTER
Start Program “A or B or C”
MANUAL PROGRAM DOES NOT WORK WITH
THE MC-E CONTROLLER. A MANUALLY
STARTED PROGRAM RUNS CONTINUOUSLY.
o In manual station mode, use the UP arrow
button to go beyond the highest station. “P-A”
appears. Press the UP button again for “P-B” or
again for “P- C”.
o With the desired Program displayed, press
ENTER for a sequential station run.
ASC (All Stations Cycle) To run all stations, in
sequence, see Start a Program, above. Use the UP arrow
key to move above “PGM C” to “TEST ALL” mode;
Use the UP or DOWN buttons to set the running time
(all stations will run the same length of time, in
sequence, from lowest to highest number).
Press ENTER to start. (Leave the transmitter on during
the TEST ALL sequence.)
14.