User's Guide

OPERATING INSTRUCTIONS:
Power Up or Power Down the transmitter
o Press the red MODE/PWR button to turn on
o Press and hold MODE/PWR to turn off
With the exception of All-Station-Test mode,
turning off the transmitter does not turn off a
station in operation. (See Stop all watering.)
Automatic Power Down of transmitter
o To extend battery life, five minutes of button
inactivity will shut off the transmitter
Turn on a station or zone (with transmitter on)
o Press the UP or DOWN arrow button to scroll to
the station number desired
o Use RIGHT ARROW key to move to run time
o Use the UP or DOWN arrow button to set the
station’s 1-time manual running time
o Press ENTER to start the station
(The controller may display a differing
countdown. It has been overridden by the
remote’s countdown.)
To Stop all watering, press the Cancel button
Change from one running station to another
o Use UP or DOWN button to find the station
o Press RIGHT ARROW key to move to run time
o Set running time with the Up or Down button
o Press ENTER to turn on the new station. The
previously running station will shut off
To select PIN number
o See previous section above on setting PIN numbers
in the mini-Receiver or in the CLIMATE LOGIC
receiver module.
13.
The line-of-sight (LOS) range from the remote, handheld
transmitters to their receivers is up to 1,000 feet. Objects in the
way and radio frequency interference will reduce the range.
Even with the above-mentioned environmental handicaps, the
range should be adequate for most residential applications.
The operation and performance of the remote kit with its
compatible controllers and the CL-R1 transmitter-only with the
CLIMATE LOGIC system are similar. This User’s Guide
explains the installation of the R-100-KIT and covers the use
and operations the remotes have in common. The CLIMATE
LOGIC weather-sensing system has its own installation and
User’s Guide.
2.
The CLIMATE LOGIC
weather sensing system
shares its own receiver with
the CL-R1.
The individual, handheld,
transmitter, CL-R1 needs
no receiver to work with
the CLIMATE LOGIC.