User's Guide

To set the PIN in the CLIMATE LOGIC receiver module:
After setting the PIN in the handheld transmitter (see
above), open the CLIMATE LOGIC receiver module.
Press the MENU button to get to the Main Menu on the
module’s display
Repeatedly press the UP or Down key on the module to
move the cursor to REMOTE.
Press ENTER to get to the Remote PIN screen.
Repeatedly press the UP or DOWN key to set the first digit
on the left.
Press NEXT to move one digit to the right.
Repeat the steps to set all four digits in the PIN.
With your desired PIN displayed, press SAVE
11.
The handheld transmitter gets its power from a user-supplied,
9-volt, battery. The kit’s mini-receiver has a single cable and
plug for simple connection to most controllers. The controller
to which it is connected powers the CL-MR mini-receiver. The
adapter cable, CMR-ADP, is for connection to the early models
of the MC-E “Blue” (later models have the RJ socket) and for
the KwikDial controllers. Those controllers do not have RJ
sockets for their remote ports.
The 5-position header on one end of the cable slides on to a 5-
pin connector in the controller. On its other end, the cable
provides the RJ- connector for the CL-MR mini-receiver’s
cord.
QUICK START UP:
Install a fresh 9-volt battery into the CL-R1 Remote by
removing the three screws from the battery cover on the back
of the transmitter. Snap the battery on to the battery clip, place
the battery into the compartment, and reinstall the cover with
its three screws.
.4