VEHICLE IDENTIFICATION (VIN} NUMBER A Vehicle Identification Number identifies your Wheel Horse attachment. This number should always be referred to when consulting with yer dealer or factory conceding service, replacement parts, or questions you may have. I VIN plate is removed during repair operations it should always be replaced. For your reference, record number from VIN plate on your attachment: T Vi INSTALLATION ATTACH HEIGHT CONTROL LEVER Height contra lever must be attached fo Rear Discharge 42 in.
On 37" mowers, install belt through front of mower deck around spindle pulleys with “Wheel Horse” Nome and “Part Number” sawing (Figs. 8 & 9} Continue belt strands around front idler pulleys {Figs. 8 & 10). Place drive belt on inside groove of PTG pulley (Fig. 10, BELT ROUTING 15 CRITICAL, MAKE SURE BELT IS ROUTED AS SHOWN IN FIGURE 8.
n . ADJUSTMENT KNO: LIRE PULLEYS seat Inch Mower PTO Pulley Hold pulleys in agonist thrust color and adjust drive belt tension by turning adjusting knob counterclockwise until fop strand of drive belt can be depressed approximately 1 inch (2.5 cm) under moderate finger pressure ot o mid-point between pulleys (Figs. 11 & 12). Remove idler pulley and cover nut; mike sure spacer remains on shaft {Fig. 11). Install cover with plat pin in slot of support (Fig. 13). Reinstall cover nut ond tighten, FIG.
LEVEL ADJUSTMENT ROD, TRUNCATION & NUT 2 L BUMPERS Sl : TRANSPORT LEVEL STOPS’K’ FIG. Mower Adjustments LEVEL ADJUSTMENT ROD, TRUNCATION & NUT BUMPERS TRANSPORT LEVEL TOPS Haze FG.17. Mower Adjustments ¥ TRANSPORT LEVEL §TOPS ’\A ) ser (107 tm) Rear Discharge Mower Adjustments TRACTOR LIFT BAR — TRUNCATION AND LIFT ROD ADJUSTMENT This adjustment involves parts footed on tractor {Fig. 19).
OPERATION IMPORTANT Every time mower is installed, check for proper operation of PTO clutch and brake. Adjustment of PTO is covered in tractor Operator's Manual. First dime mower is used, or after installing a new mower drive belt, recheck belt tension after first 20 minutes of operation {allow belt to cool before checking tension). A CAUTION A The mower can be equipped with o recur grass bugger attachment. This attachment is supplied with a special “high if#" blade or blades.
UNDERSIDE CLEANING It is of vital importance fo clean underside of mower deck frequently. Accumulation of netted clippings seriously impairs mower's ability o “lift” grass blades info cutting position and discharge clippings evenly. Matted gross clogging underside of mower is often times o cause of uneven cutting. REPLACEMENT BELTS Be sure to purchase genuine Wheel Horse belts for replacement purposes as these belts are designed specifically for eek application. MOWER DRIVE BELT REPLACEMENT (Refer to Figs.
Product information and specifications ore shown herein as of the time of printing. Wheel Horse Products, Inc. reserves fhe right fo change product specifications, designs and standers equipment without notice and without incurring obligation.