User's Manual

Sensors

e Sensors function allows you to assign a rain sensor to each of the schedules. Schedules with a rain sensor assigned will not water when

the sensor is activated.

Step 1 – While in the ADVANCED menu, use the Up

or Down arrows to select the SENSORS. Press SELECT .

Step 2 – Use the Up

or Down arrows to select the sensor you want to set.

Step 3 – Use the Left

or Right arrows to select the schedule.

Step 4 – Use the Up

or Down arrows to place a check mark under the desired schedules to assign the rain sensor. When the

rain sensor is activated, EVOLUTION

will prevent schedules from operating. Replace the check mark with a dash to disable

the sensor for that schedule.

SENSORS

A B Ca

RAIN

Use the Right arrows to select to access the sensor setup screen.

RAIN SENSOR

RAIN DELAY OFF

CURRENT STATE IS DRY

Step 5 – Select Rain Delay. Press SELECT or Right arrows to navigate to the parameter.

Step 6 – Use the Up

or Down arrows to set a delay of 1-14 days or OFF. e rain delay is the waiting period after the rain

sensor is detected to be dry.

Step 7 – Press the BACK

arrow to return to the previous menu or HOME to return to the main screen.

Diagnostics

e EVOLUTION

controller provides a diagnostic function to check whether the system’s zones are properly functioning. When

activated, the controller will test each available zone. EVOLUTION

will display dashes (--) for zones that are being tested and have not

been tested, OK for zones working within the current draw range, OVERCRNT for zones drawing above the recommended current draw,

or SHORT for zones that have a grounded circuitry.

DIAGNOSTICS

ZONE TEST

ZONE CURRENT TEST

MASTER VALVE OK

ZONE 1 OVERCRNT

ZONE 2 SHORT

ZONE 3 ––