User manual

Groundsmaster 4000--D/4010--D Hydraulic SystemPage 4 -- 105
Removal (Fig. 78)
1. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
2. Topreventcontaminationofhydraulicsystemduring
manifold removal, thoroughly clean exterior of filter
manifold and fittings.
3. Disconnect hydraulic lines from filter manifold and
putcapsorplugsonopenhydrauliclinesandfittings.La-
beldisconnectedhydraulic lines for proper reassembly.
4. Remove filter manifold from the frame using Figure
78 as a guide.
5. Ifhydraulic fittings are to be removed from manifold,
mark fitting orientation to allow correct assembly. Re-
move fittings from manifold and discard O--r ings.
Installation (Fig. 78)
1. Iffittings were removed from manifold, lubricate and
place new O--rings onto fittings. Install fittings into man-
ifold openings using marks made during the removal
process to properly orientate fittings. Tighten fittings
(see Hydraulic Fitting Installation in the General Infor-
mation section of this chapter).
2. Install filter manifold to the frame using Figure 78 as
a guide.
3. Removecapsandplugsfromfittingsandhoses.Us-
inglabelsplacedduringmanifoldremoval,properlycon-
necthydrauliclinestomanifold(seeHydraulicHoseand
Tube Installation in the General Information section of
this chapter).
4. Makesurehydraulictankisfull.Addcorrectoilifnec-
essary before returning machine to service.
Hydraulic
System