User manual

Groundsmaster 4000--D/4010--DPage 6 -- 18Axles, Planetaries and Brakes

8. Installsteeringcylindertoaxleassembly(seeSteer-

ingCylinderInstallation in the Serviceand Repairssec-

tion of Chapter 4 -- Hydraulic System).

9. Install hydraulic motor to axle assembly (see Rear

Axle Motor Installation in the Service and Repairs sec-

tion of Chapter 4 -- Hydraulic System).

WARNING

Failure to maintain proper wheel lug nut torque

could result in failure or loss of wheel and may

result in personal injury.

10.Install wheels to axle.

11.Lower machine to ground. Torque wheel lug nuts

from 85 to 100 ft--lb (115 to 135 N--m).

12.Fill axle withSAE 85W--140 weightgear lube. Lubri-

cant capacity is approximately 80 fl. oz. (2.37 liters) for

the axle and 16 fl. oz. (0.47 liters) for the gearbox.

13.Check rear wheel toe--in and adjust if necessary.

14.Check steering s top bolt adjustment. When the

steering cylinder is fully extended (right turn), a gap of

1/16” (1.6 mm) should exist between bevel gear case

casting and stop bolt onleftaxle case. Figure 15 shows

stop bolt location.

1. Steering stop bolt 2. Bevel gear case (LH)

Figure 15