User manual

Groundsmaster 4000--D/4010--D Cutting DecksPage 8 -- 13
Removal (Figs. 11 and 12)
1. Park machine on a level surface, lower cutting
decks, stop engine, apply parking brake and remove
key from the ignition switch.
2. Removecovers from cutting deck to allow access to
blade spindle.
3. If drive spindle is to be serviced, remove hydraulic
motor from cutting deck (see Cutting Deck Motor Re-
moval in the Service and Repairs Section of Chapter 4
-- Hydraulic Systems). Position motor away from
spindle.
4. Loosen idler assembly to release drive belt tension
(see Idler Assembly Removal in this section). Remove
drive belt from spindle to be serviced.
5. Startthe engineand raise the cutting deck. Stop en-
gine and remove key from the ignition switch. Latch or
block up the cutting deck so it cannot fall accidentally.
6. Removecuttingblade,anti--scalpcupandbladebolt
from spindle to be serviced.
7. Remove spindle housing assembly from deck.
A. For driven spindle assemblies, remove eight (8)
flange head screws with flange nuts that secure
spindle to deck.
B. Fordrivespindleassemblies,removefour(4)cap
screws with washers that secure spindle and hy-
draulic motor mount to deck. Remove motor mount.
Then, remove four (4) flange head screws with flan-
ge nuts that secure spindle to deck.
C. Lift spindle assembly from deck.
Installation (Figs. 11 and 12)
1. Positionspindleoncutting decknotingorientation of
greasefitting(Fig.11).Securespindleassemblytodeck
with removed fasteners.
2. Installcuttingblade,anti--scalpcupandbladeboltto
spindle. Tighten blade bolt from 88 to 108 ft--lb (120 to
146 N--m).
3. Slowly rotate cutting blades to verify that blades do
not contact any deck components.
4. Install drive belt to spindle pulleys and idler pulley.
Adjustdrivebelttension(seeIdlerAssemblyInstallation
in this section).
5. Ifdrive spindle was removed, install hydraulic motor
to cutting deck (see Cutting Deck Motor Installation in
theServiceandRepairs SectionofChapter4 -- Hydrau-
lic Systems).
IMPORTANT: Pneumatic grease guns can produce
airpocketswhenfilling largecavitiesandtherefore,
are not recommended to be used for proper greas-
ing of spindle housings.
6. Attach a hand pump grease gun to grease fitting on
spindle housing and fill housing cavity with grease until
grease starts to come out of lower seal.
7. Install covers to cutting deck.
1. Deck (RH shown)
2. Driven spindle
3. Drive spindle
4. Flange head screw
5. Flange nut
6. Drive belt
7. Washer
8. Cap screw
9. Blade
10. Anti--scalp cup
11. Blade bolt
Figure 12
1
2
6
4
5
3
7
8
9
10
11
88 to 108 ft--lb
(120 to 146 N--m)
Cutting
Decks