Specifications
15
2015 Toro Commercial Equipment Guide 15-003-T Rev. 2/15
Groundsmaster
®
3500-G Specifications
*
The Groundsmaster 3500-G is manufactured
in Tomah, WI ISO 9002 Certified Plant.
GROUNDSMASTER 3500-G, GAS, MODEL 30809
ENGINE
Kubota
®
32.7 hp (24.4 kW) gas engine. 58.7 cu. in. (.962 liter) displacement. Oil capacity: 3.6 quarts (3.4 liters) with standard oil filter.
FUEL CAPACITY
10 gallons (37.9 liters).
CONFIGURATION
Rear mounted engine, front operator position. Two post ROPS, seat belt and slope indicator standard. Sidewinder™ cutting unit system.
TRACTION DRIVE
3-wheel drive in mow and transport. Series/Parallel™ hydrostatic, closed-loop transmission provides infinitely variable ground speed in forward and reverse. Variable
displacement piston type pump.
GROUND SPEED/
CLEARANCE
Mow: 0-6 mph (0-10 km/h), mow speed is factory preset at 6 mph but is adjustable; Transport: 0-9 mph (0-14km/h);
Reverse: 0-4 mph (0-6 km/h). Ground Clearance: 6" (15.3 cm).
CONTROLS
Forward and reverse traction control pedals; mow/transport foot lever; hand activated parking break; hand operated ignition key switch; tilt steering wheel lock; PTO
switch; throttle; joystick control for deck raise and lower as well as moving decks side-to-side; cutting deck transport lock.
GAUGES &
DIAGNOSTICS
Fuel gauge and hour meter. Light cluster with check engine and charge indicator lights, low engine oil pressure and high coolant temperature warning lights (high
temperature safety shut off).
ELECTRICAL &
INTERLOCKS
Traction pedal, operator presence in seat, PTO engage or disengage, and cutting deck mow or transport safety interlock switches. Parking break set prohibits
movement through traction pedal. 40 amp alternator and 12-volt, 585 CCA battery.
HYDRAULICS
Open center, manual valves, gear pump hydraulic system. System capacity approximately 3.5 gallon (13.2 liter) reservoir.
STEERING
Hydraulic power steering, tilt wheel.
TIRES/WHEELS
20 x 12-10, 4-ply rating, Turf Tread front tires. 20 x 10-10, 4-ply rating, Turf Tread rear tires.
BRAKES
Dynamic through hydrostatic transmission service brake. Hand actuated over center, drum type parking brake.
OVERALL
DIMENSIONS
Height Length Width Wheelbase
70.8" (180 cm) w/ROPS 116" (295 cm) 71.8" (182 cm) with 68" (173 cm) WOC 59.5" (151 cm)
75.8" (193 cm) with 72" (183 cm) WOC
WEIGHT
2,145 lbs. (1,075 kg) with cutting units.
WARRANTY
Two-year limited warranty. Refer to operator’s manual for further details.
CERTIFICATION
Complies with ANSI B71.4-2012 and EN5395.
CUTTING DECKS
TYPE
3 Contour™ Plus 27" (69 cm) rear-discharge rotary with rear roller on each deck. Sidewinder system allows all three decks to slide right and left 12" (30 cm) of
center, 24" (61 cm) total travel. Mulching kit optional.
WIDTH OF CUT
68" (173 cm), standard and 72" (183 cm) optional. Deck overhang for trimming is 12" (30.5 cm) at 68" (173 cm) width of cut and
14" (35 cm) at 72" (183 cm). Overlap: 6.5" (16.5 cm) at standard width of cut.
HEIGHT OF CUT
.75"-4" (1.9-10.2 cm) in .25" (.6 cm) increments.
MOWING RATE
Mows up to 4.1 acres/h (1.7 hectares/h) at 6 mph (10 km/h) (assumes no overlap or stops).
CONSTRUCTION
10-gauge steel constructed chambers with 12-gauge welded reinforcements. 1.5" (3.8 cm) square x .25" (.6 cm) wall tube with
7-gauge side supports. Spindle support 3/16" (.48 cm) high-strength steel and 10-gauge exterior channels.
SPINDLE
ASSEMBLY
Ductile cast iron spindle housing. Dual greaseable tapered roller bearings. 1.25" (3.2 cm) diameter solid cold finished steel spindle shaft. Splined connection
between spindle shaft and pulley. Welded blade retainer plus anti-scalp cups.
ANTI-SCALP FEATURES
6" (15 cm) anti-scalp cups on each blade.
MULCHING KIT
Model 30836
ACCESSORIES
BIMINI SUNSHADE
Model 30358
WORK LIGHT
Model 30841
UNIVERSAL SUNSHADE
Model 30349 (White), Model 30552 (Red)
* Specifications and design subject to change without notice. Products depicted in this literature are for demonstration purposes only.
Actual products offered for sale may vary in use, design, required attachments and safety features. See distributor for details on all warranties.