User manual

Reelmaster 7000 Page 6 -- 21 Axles, Planetaries and Brakes
5. Determine necessary quantity of support shims.
A. Lubricate the axle case support bushing with a
thin coat of grease and slide axle case support onto
knuckle pin.
B. Positionsupports himsthatwereremovedduring
disassembly between axle case support and axle
case. Install mounting screwsintoaxle case. Slowly
tighten screws while frequently checking for clear-
ance (vertical endplay) between axle case support
and knuckle pin. If binding of components is noted
beforescrewsarefullytightened,addadditionalsup-
portshims.Torquescrewsfrom 57 to 67 ft--lb(77to
91 N--m).
C. Use dial indicator to measure vertical endplay of
axle case (Fig. 20).
AXLE CASE ASSEMBLY ENDPLAY:
0.001 to 0.008 inch (0.02 to 0.20 mm)
D. Adjustendplaybyincreasingorreducingnumber
of axle case support shims.
NOTE: Axle case support shims are available in
0.004 inch (0.1 mm), 0.008 inch (0.2 mm) and 0.016
inch (0.4 mm) thickness.
6. After correct support shims have been determined,
removemountingscrews,applyheavystrengththread--
locking compound to screw threads, reinstall screws
and torque from 57 to 67 ft--lb (77 to 91 N--m).
IMPORTANT: Correct engagement between bevel
gears is critical to axle performance and durability.
7. Temporarilyinstallthebevelgearcase/axlecaseas-
sembly on the axle support. Position a dial indicator at
the tooths center. Prevent the axle from turning and
measure the upper bevel gear to differential shaft gear
backlash (Fig. 21).
UPPER BEVEL GEAR BACKLASH:
0.004 to 0.016 inch (0.10 to 0.40 mm)
8. Adjustbacklashbyincreasingorreducingaxlebear-
ingshimthickness(seeDifferentialShaftsinthissection
of this manual).
NOTE: Axle bearing shims are available in 0.004 inch
(0.1 mm), 0.008 inch (0.2mm)and0.020 inch (0.5 mm)
thickness.
1. Axle case support
2. Axle case
3. Bevel gearcase
4. Dial indicator
5. Knuckle pin
6. Support shim location
Figure 20
1
2
4
5
3
6
VERTICAL
ENDPLAY
57 to 67 ft--lb
(77to91N--m)
1
2
3
4
5
1. Axle support
2. Upper bevel gear
3. Differential shaft gear
4. Dial indicator
5. Axle bearing s hims
Figure 21
1. Axle cover assembly
2. Lower bevel gear
3. Axle gear
4. Dial indicator
5. Axle bearing s hims
Figure 22
1
2
3
4
5
Axles, Planetaries
and Brakes