User manual

Reelmaster 7000Hydraulic System Page 4 -- 6
Hydraulic Hoses
Hydraulichosesaresubject toextremeconditionssuch
aspressuredifferentialsduring operationandexposure
to weather, sun, chemicals, very warm storage condi-
tionsormishandlingduringoperationandmaintenance.
These conditions can c ause hosedamage and deterio-
ration. Some hoses are more susceptible to these
conditions than others. Inspect all machine hydraulic
hoses frequently for signs of deterioration or damage:
Hard, cracked, cut, abraded, charred, leaking or
otherwise damaged hose.
Kinked, crushed, flattened or twisted hose.
Blistered, soft, degraded or loose hose cover.
Cracked, damaged or badly corroded hose fittings.
When replacing a hydraulic hose,be sure that the hose
is straight (not twisted) before tightening the fittings.
This can be done by observing the imprint (layline) on
thehose.Usetwowrenches;holdthehose straightwith
one wrench and tighten thehose swivel nutonto the fit-
ting with the other wrench (See Hydraulic Hose and
Tube Installation in this section). If the hose has an el-
bowatoneend,tightentheswivelnutonthatendbefore
tightening the nut on the straight end of the hose.
For additional hydraulic hose information, refer to Toro
Service Training Book, H ydraulic Hose Servicing ( Part
Number 94813SL).
WARNING
Beforedisconnectingorperformingany workon
hydraulic system, relieve all pressure in system
(seeRelievingHydraulic SystemPressure inthis
section).
Keepbodyandhandsawayfrompinholeleaksor
nozzles that eject hydraulic fluid under high
pressure. Use paper or cardboard, not hands, t o
search for leaks. Hydraulic fluid escaping under
pressure can have sufficient f orce to penetrate
the skin and cause serious injury. If fluid is in-
jected into the skin, it must be surgically re-
moved within a f ew hours by a doctor familiar
withthistypeofinjury.Gangrenemayresultfrom
such an injury.