user manual

Groundsmaster 4100--D Hydraulic SystemPage 4 -- 85
Removal (Fig. 59)
NOTE: The ports on the manifold are marked for easy
identification of components. Example: P1 is a piston
pumpconnectionportandSVisthelocationforthesole-
noid valve (See Hydraulic Schematic in Chapter 9 --
FoldoutDrawingstoidentifythefunctionofthehydraulic
lines and cartridge valves at each port).
1. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of this section.
2. Topreventcontaminationofhydraulicsystemduring
manifold removal,thoroughly clean exterior of manifold
and fittings.
3. Disconnect electrical connector from the solenoid
valve.
4. Disconnect hydraulic lines from manifold and put
capsor plugson openhydraulic linesand fittings.Label
disconnected hydraulic lines for proper installation.
5. Remove hydraulic manifold from the frame using
Figure 59 as guide.
Installation (Fig. 59)
1. Install hydraulic manifold to the frame using Figure
59 as guide.
2. Remove caps and plugs from fittings and hoses.
Properly connect hydraulic lines to manifold.
3. Connect electrical connector to the solenoid valve.
Hydraulic
System