user manual

Groundsmaster 4100--D Page 5 -- 9 Electrical System
Adjustments
Wing Deck Position Switches
Adjustment
1. Park machineon alevels urface, lowercutting deck,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Remove switch cover from deck to allow access to
position switch that requires adjustment.
NOTE: Use Deck Proximity Switch Adjustment Tool
(TOR4095) to assist with switch adjustment (see Spe-
cial Tools).
3. Loosen two (2) lock nuts that secure switch bracket
to center cutting deck (Fig. 7).
4. Whenadjusting switchlocation,thetargetsurfaceof
position switch should be approximately 0.188” (4.8
mm) from actuator tab on wing deck link (Fig. 8).
5. Whenwingdeckpositionswitchisproperlyadjusted,
hydraulic motoron wingdeck shouldturn offwhen wing
deck is raised and wing deck latch opens.
6. For switch testing information, see Wing Deck Posi-
tion Switches in the Component Testing section of this
chapter.
1. Position switch
2. Lock nut (2 used)
3. Flat washer (2 used)
4. Switch bracket
5. Carriage screw (2 used)
6. Center cutting deck
7. Screw (2 used)
Figure 7
2
1
3
4
5
6
7
1. Position switch
2. Actuator tab
3. Wing deck link
Figure 8
0.188”
(4.8 mm)
3
1
2
Electrical
System