user manual

Groundsmaster 4100--D Page 6 -- 17 Axles, Planetaries and Brakes
Bevel Gear Case and Axle Case
The followingprocedures assume therear axle assem-
blyhasbeenremovedfromthemachine(seeRearAxle
Assembly Removal in this section).
Bevel Gear Case and Axle Case Removal
1. Remove the mounting screws, nuts and lock wash-
ers. Remove the bevel gear case/axle case assembly
and O-ring from the axle support (Fig. 15).
2. Mark both right and left bevel gear case/axle case
assemblies.
IMPORTANT: Do not interchange right and left bev -
el gear case/axle case assemblies.
1
2
3
4
5
6
1. Cap screw (4 used)
2. Lock nut (2 used)
3. Lock washer (2 used)
4. Axle support
5. Bevel gear case/axle
case assembly
6. O-ring
Figure 15
35 to 41 ft--lb
(47to56N--m)
35 to 41 ft--lb
(47to56N--m)
3. Remove the axle c over mounting screws. Remove
theaxlecoverfromtheaxlecaseasanassembly
(Fig. 16).
1. Axle case
2. Axle cover assembly
3. Mounting screw (6 used)
4. O-ring
Figure 16
1
2
3
4
17 to 20 ft--lb
(23to27N--m)
4. Removetheaxlecases upportmountingscrews,the
axle case support and the support s hims (Fig. 17).
1. Axle case
2. Axle case support
3. Mounting screw (2 used)
4. Support shim
Figure 17
1
2
3
4
57 to 67 ft--lb
(77to91N--m)
Threadlocking
Compound
Axles, Planetaries
and Brakes