Product Manual
Table Of Contents
- safety symbols
- SECTION 1: important safe operation practices
- California Proposition 65
- General Operation
- Slope Operation
- Do:
- Do Not:
- Children
- Towing
- Safe Handling of Gasoline:
- SECTION 3: Slope Gauge
- SECTION 4: tractor set-up
- Attaching The Steering Wheel
- Connecting the Battery Cables
- Tire Pressure
- Attaching The Seat
- Shipping Brace Removal
- Setting the Gauge Wheels
- Tools Required
- Gas and Oil Fill-up
- SECTION 5: know your lawn tractor
- Throttle/Choke Control
- Brake Pedal
- Deck Lift Lever
- Ignition Switch Module
- Drive Pedal
- Systems Indicator Monitor / Hour Meter
- LCD
- Brake
- PTO (Blade Engage)
- Battery
- Electric PTO / Blade Engage Knob
- Cruise Control Lever
- Parking Brake Lever
- SECTION 6: operating your lawn tractor
- Safety Interlock System
- Reverse Caution Mode
- Starting the Engine
- Stopping the Engine
- Driving The Tractor
- Driving On Slopes
- Setting The Cruise Control
- Engaging the Parking Brake
- Engaging the PTO (Blades)
- Using the Deck Lift Lever
- Mowing
- Moving the Tractor Manually
- SECTION 7: making adjustments
- Seat Adjustment
- Leveling the Deck
- Front To Rear
- Side to Side
- Steering Adjustment
- SECTION 8: maintaining your lawn tractor
- Engine
- Changing Engine Oil
- Draining the Oil
- Fuel Filter
- Cleaning the Engine and Deck
- Lubrication
- Engine
- Pivot Points & Linkage
- Front Wheels
- SECTION 9: SERVICE
- Tires
- Fuse
- Cutting Blades
- Battery
- Jump Starting
- Charging
- Cutting Deck Removal
- Changing the Upper Deck Belt
- SECTION 10: off-season storage
- SECTION 11: maintenance chart
- SECTION 12: troubleshooting
- SECTION 13: specifications*
- electric schematic
- SECTION 2: SAFETY AND INSTRUCTIONAL LABELS
17
Starting the Engine
WARNING: Do not operate the tractor if the
interlock system is malfunctioning. This
system was designed for your safety and
protection.
NOTE: Service the engine with gasoline and oil as
instructed in the separate engine manual packed
with your tractor. Read instructions carefully.
1. Insert the tractor key into the ignition switch
module.
2. Place the PTO (Blade Engage) knob in the
disengaged (OFF) position.
3. Engage the tractor’s parking brake.
4. Activate the choke control.
5. Turn the ignition key clockwise to the START
position. After the engine starts, release the key. It
will return to the NORMAL MOWING position.
IMPORTANT: Do NOT hold the key in the START
position for longer than ten seconds at a time. Doing so
may cause damage to your engine’s electric starter.
6. After the engine starts, deactivate the choke
control.
NOTE: Do NOT leave the choke control on while
operating the tractor. Doing so will result in a "rich" fuel
mixture and cause the engine to run poorly.
Stopping the Engine
WARNING: If you strike a foreign object,
stop the engine and remove the ignition key.
Thoroughly inspect the machine for any
damage. Repair the damage before restarting
and operating.
1. If the blades are engaged, place the PTO/Blade
Engage knob in the disengaged (OFF) position.
2. Position the throttle control between half-throttle
and the FAST (rabbit) position.
3. Turn the ignition key counterclockwise to the STOP
position.
4. Remove the key from the ignition switch to prevent
unintended starting.
Driving The Tractor
WARNING: Avoid sudden starts, ex-
cessive speed and sudden stops.
WARNING: Do not leave the seat of the
tractor without first placing the PTO/Blade
Engage knob in the disengaged (OFF)
position, pressing the brake pedal and
engaging the parking brake. If leaving the
tractor unattended, also turn the ignition key
off and remove the key.
• Briefly depress the brake pedal to release the
parking brake. Move the throttle lever into the FAST
(rabbit) position.
• To travel FORWARD, slowly press the upper
portion of the drive pedal forward until the desired
speed is achieved. See Figure 10.
Figure 10
• To travel in REVERSE, check that the area behind
is clear then slowly press the lower portion of the
drive pedal with the ball of your foot (NOT your
heel) until the desired speed is achieved. See
Figure 10.
IMPORTANT: Do NOT attempt to change the direction of
travel when the tractor is in motion. Always bring the
tractor to a complete stop before pivoting the drive
pedal from forward to reverse or vice versa.
Brake Pedal
Drive Pedal