User's Manual

1 of 3
User Manual:
Toro Commercial Equipment Remote
FCC ID: OF7PFB1 IC: 3575A-PFB1
Models: 44538
07066
The Toro Commercial Equipment Remote (TCER) is a handheld transmitting Remote
and equipment mounted Receiver controller designed to operate wireless capable Toro
Power Equipment remotely. All installation, operation and service instruction must be
followed to insure safe and proper use of the wireless devices and power equipment.
Remote Receiver:
The TCER is interfaced with equipment through the two multi-pin connectors designated
as P1 and P2. In order to allow proper operation of the Receiver module, the antenna is
permanently attached to the Receiver module and its orientation is shown below in Figure
1. The Receiver module gets mounted high on the equipment with the antenna away
from metallic objects allowing visibility to desired operator use locations. A
preconfigured mounting location is present on the Remote capable equipment and the
equipment control wires will only connect at that location.
Figure 1: Receiver Module Figure 2: Handheld Transmitter
The Receiver module connector pins are shown in the schematics and drawings and are
connected to host equipment at the designated mounting location. The Receiver module
power of 7-30 Vdc is supplied by the host equipment and all Relay driven outputs,
isolated from the Receiver circuitry, are interfaced via the P1 and P2 connectors.
Voltages below 6 volts will result in the Receiver entering a standby then shutdown mode
until the input voltage rises within proper operating specifications. The antenna should
not be modified and must not be co-located or operated in conjunction with any other
antenna or transmitter.
Handheld Remote Transmitter:
The handheld Remote Transmitter (figure 2) consists of 6 buttons, an internal PCB loop
antenna and is powered by three 1.5 volt alkaline AAA batteries. The transmitter
operation will cease after the combined battery voltage drops below the operational
Fixed dipole
Antenna
Receiver
Module
P1
P2