Service Manual

measured
Fig. 21
Washer Washer
Fig. 22
37 Press loose or broken dowel pin out. Remove
retaining ring and washer from end of control shaft.
Remove control shaft outward from the cover.
10
” Pipe Plug
Fig.
23
38 Tap hole drilled with 1/8” pipe tap. Install 1/8” flush
type pipe plug.
39 Lubricate a new control shaft and install in cover.
Replace washer and retaining ring on end of control
shaft. Press new dowel pin through shaft leaving 1%
inch of dowel extending from shaft.
Important: When pressing the new dowel pin into
the control shaft, the Woodruff key in control shaft
must
be to the left looking at the threaded end of
shaft.
Cover
Fig. 24
40 Lubricate I.D. of new oil seal with clean lubricant.
Then press or tap seal in bore until completely seated.
Oil Seal
Cover
Fig.
25
Lip
Seal
Cover
. . . . . . . . . . . . . . . . . . . . . .
Fig. 26
41 Lubricate inner surface of the lip seal with a clean
lubricant. Press or tap seal into the bottom position in
cover counter bore.
Important: Be careful not to damage the inner
portion of the oil seal. Excessive pressing or
driving of the
oil seal will damage the rubber
portion of the seal.
Retaining
Ring
Fig.
27