Installation and Programming Guide

Before setting the schedule, decide whether you want to use the controller’s daily

schedule option or the interval SKIP DAYS option. The daily option gives you the option

of selecting particular days to water in no particular order (for example, water every

Monday, Wednesday and Saturday).

Daily Schedule Option

Step 1 - Position the Program Switch to A.

Step 2 - Move Function Switch to SET PROGRAMS.

Step 3 - Position the Multi-Function Dial to Sun.

Step 4 - Use the +/- button to select between ON or OFF.

Step 5 - Repeat this procedure to each succeeding day of the week.

Repeat the above steps if you wish to use programs B and C.

Note: When using this schedule option, make sure that the Skip Days is set to OFF.

Skip Days Schedule Option

Step 1 - Position the Program Switch to A.

Step 2 - Move Function Switch to SET PROGRAMS.

Step 3 - Position the Multi-Function Dial to Skip Days.

Step 4 - Use the +/- button to set the desired daily interval (for example, 3 for once every

third day.

Step 5 - Turn the Multi-Function Dial to Today and use the +/- Buttons to set which

day in the cycle today should be.

Repeat the above steps if you wish to use programs B and C.

Moving the Function Switch to the RUN setting will activate the program you have just

entered.

Step 1 - Move the Function Switch to OFF

Step 2 - Move the Program Switch to the program you wish to check

Step 3 - Turn the dial to any of the parameters you want to check.

Note: With the Function Switch in the OFF position, you can check, but you can not

change the parameters in the program.

Setting Program Schedule

Activating the Controller

How to Check Your Program

Note: While the Function Switch is in the RUN position, the Program Switch will

have no effect. The controller will run all three programs at their designated start times

even if the Program Switch is positioned at program A, B or C.