Installation and Programming Guide

Program Switch - Used to select from the three different programs (A, B and C)
when setting program. It is also used to select which pre-set program (A, B or C) to run
for semi-automatic operation.
Function Switch - Used to stop a program’s watering cycle and any valves that are
currently running if positioned to OFF or STOP. In this mode, all programs are retained
and watering will not resume until the switch is returned to RUN or Manual. To set or
change the controller’s programs, position the Function Switch to Set Programs. Place
the switch into the Run or Manual position to operate manually or activate the controller’s
automatic watering cycles.
Semi-Auto Start Button - Used in conjunction with the Program Switch. When
depressed, it immediately starts the program selected at the Program Switch, (A, B or
C), regardless of its automatic start time.
Manual Start Button - Used
in conjunction with the Multi-
Function Dial and +/- Buttons.
When depressed, it operates the
selected valve indicated by the
Multi-Function Dial for the duration
entered by the user.
Multi-Function Dial - Used to
set, check or change program
information in conjunction with the
+/- Buttons. After using the dial,
always return it to the Current Time
position.
+/- Buttons - Used in
conjunction with Multi-Function
Dial to set or change program
information. It is usually used to
advance or decrease numbers or
toggle from ON or OFF selection.
Single finger taps to either button
will advance or reduce data one
character at a time. Holding either
button down will advance data at a
rate of 12 characters per seconds.
LCD Display - Shows the current
operation.
8
SEMI-AUTO
Start A, B, or C
OFF
or
STOP
RUN
or
Manual
MANUALSET PROGRAMS
S
T
A
R
T
T
I
M
E
S
S
C
H
E
D
U
L
E
V
A
L
V
E
R
U
N
T
I
M
E
S
CURRENT
TIME
Today
Sun
Mon
Tue
Wed
Thu
Fri
Sat
Skip Days
1
1
2
12
11
10
4
3
5
6
7
8
9
2
3
RD - 1200
Figure 5
Program Switch
LCD Display
+/- Buttons
Multi-Function
Dial
Manual Start Button
Function Switch
Semi-Auto
Start Button
Buttons and Switches Functions