User's Manual

Check the range between

the remote and controller

1. Connect the controller’s transformer following these steps

• Do not plug in the transformer!

• First, remove the access cover from the controller by pushing

inward on the finger grips on both sides and sliding the cover

forward and off the controller.

• Slip the 3-wire cord from the transformer through the small

whole on the left hand side of the bottom of the controller’s

case.

• Pull about 6 inches of cable into the controller and tie a loose,

half knot in the cord to prevent it from being pulled back out.

• With a screwdriver, connect the red wire to the left hand

terminal on the terminal strip, the black wire to the terminal

that is second from the left and the green wire to the third

screw terminal from the left.

• Connect the 9-volt battery to the battery clip and replace the

access cover.

• Without mounting the controller, you can now plug it in to

prepare for a communications check.