Owner's Manual

8
Sequence Related Commands Under Normal Mode
Command Operation
00 h tt
If running a sequence of stations, use this command to set the
run time duration. As an example, sending 00 1 30 command
instructs the satellite unit to run a sequence for
1 hour and 30
minutes.
nn # Send this command to start irrigation for all stations in
sequence, where
nn is the first station to irrigate.
3 # Sending this command will increment the currently operating
station in sequence. As an example, if station 16 is currently in
operation and the
3 # command is transmitted, station 16 will
stop and station 17 will initiate operation.
1 # Sending this command will decrement the currently operating
station in sequence. As an example, if station 16 is currently in
operation and the
1 # command is transmitted, station 16 will
stop and station 15 will initiate operation.
00 # Sending this command will stop the satellite unit’s sequence
operation.
Semi-Auto Program Commands Under Normal Mode
Command Operation
# Cp #
This command instructs the satellite to start a specified cluster
program. The C designates the cluster number, 1 for cluster A,
2 for cluster B, etc. The p designates the program number
within the specified cluster. As an example, if command
# 24 #
is transmitted, cluster B program 4 will start.
# C3
*
This command instructs the satellite to stop the specified
cluster in operation. The
C designates the cluster number (1
for cluster A, 2 for cluster B, etc.) to stop operation.
Secure Mode - To place the satellite into Secure mode operation, send ## CCC ## command where CCC is
the satellite unit code. Press the hand-held radio’s PTT button (Push To Talk) to transmit the command. Only
the specified unit will respond to transmitted commands. Send CCC ## to exit Secure mode operation. Satellite
displays
S while in Secure mode.
Command Operation
CCC nn
Station nn (where nn is the specified station) of unit CCC
(where CCC is the unit code)will irrigate for 30 minutes. After
30 minutes, the station will stop irrigating and the satellite
waits for the next command.
CCC nn h tt Station nn of unit CCC will irrigate until the specified hour (h)
and minutes (tt) expire. As an example, entering 555 12 1 30
will energize station 12 of unit 555 for 1 hour and 30 minutes.
CCC nn nn nn Use this command to turn-on multiple units for 30 minutes.
The desired satellite stations are listed in series after the unit
number. As an example, entering 555 12 13 14 will energize
station 12–14 of unit 555.
Action
Set sequence time.
Start sequence operation.
Increment sequence.
Decrement sequence.
Stop sequence operation
Action
Start cluster program.
Stop cluster program.
Action
Turn-on station for 30
minutes.
Turn-on a station for a
specified amount of time.
Turn-on multiple stations.