System Guide

In this Chapter:

Part 1 – Program Satellites for Automatic Operations

Part 2 – Checking Unsent Changes

This chapter provides the various satellite programming procedures required

to establish and configure automatic irrigation programs.

Part 1 – Programming for Automatic Operations

1. To begin, open the Program window by choosing the Automatic

Operations under the Programming directory.

The satellite Program setup window is comprised of five main sections as

illustrated below:

1 – Toolbar

2 – Program Tabs

3 – Start Times

4 – Parameters

5 – Schedule

6 – Station Slots

1 – Program Toolbar

Program Toolbar buttons provide easy access to the most commonly used

menu functions.

Note: The toolbar functions apply only to the program page currently being

edited.

Checkup - To view a detailed

report of the current program status,

choose the checkup button in the

toolbar to open the Checkup window.

The results provided in the Checkup

window is color coded: Green

indicates Ok, Blue and Black are

informational and Red indicates a

problem exists.

Description - To provide a program description, choose the Description

toolbar button to open the Description Editor dialog box window. Type in the

description(s) or, to select an existing description, use either the drop-down

menus or description tree.

Note: In the example above, the program has been named “Primary

Secondary.” After entering the description(s) choose Save and Close to exit

the descr

iption editor.

On the Program setup window,

choose Refresh.

The prog

name will no

w be displa

ed on

the Program window title bar.

Satellite Programming