User's Manual

Slot-Stn-Time Submenu Edit Mode:

The second line of the display indicates

CAP1 = Cluster A, Program 1

as follows:

01-01-0:10 = Slot 1 - Station 1 – 10 Minutes

From the factory, the Slot and Station numbers are set to be the same; i.e., Station 1 is

assigned to Slot 1 and will run first. Station 2 will run next in Slot 2, etc. Use the

LUSTER/SCHEDULE SELECT key and the PROGRAM SELECT key to

osition the cursor under the slot field.

se the Up and Down Arrow keys ( , ) to select the slot desired.

e Up

y station in any

ven repeat the desired station within the same program. Keep in mind

at the controller will run the slots sequentially. Stations can be assigned to slots

allowing any order of programming.

select the desired cluster program.

Use the Right and Left Arrow keys ( , ) to p

Use the Right Arrow key ( ) to position the cursor under the Station field. Use th

and Down Arrow keys ( , ) to select the desired Station to run

in the slot shown.

Press the Right Arrow key ( ), again, to position the cursor under the time field. Enter

the desired run time using the Numeri ke from 0:00 to 4:15 (4 Hours and 15 Minutes)

c ys

Press ENTER ( ) to save the Slot details. Continue this process to set up all the Slots

or to view the status of the other Slots.

Note: This feature (The Slots in a Program) allows the user to run an

order desired and e