Addendum

FormNo.3439-467RevA

Workman

MDXUtilityVehicle

Addendum

Ifyouhavemorethan1machine,makeacopyofthisAddendum,andaddittoyourOperator'sManual(s).

AccessthelatestOperator'sManual(s)foryourmachineatwww.Toro.com.

AddthisAddendumtoyourOperator’sManualifyouhaveoneofthefollowingOperator’sManuals:

•3406-473(RevAorB)

•3413-372(RevAorB)

•3419-568(RevA)

•3424-804(RevA)

•3437-696(RevAorB)

CrossouttheexistingRecommendedMaintenanceSchedule(s)tableinyourOperator'sManualandreplace

itwiththetableshownbelow.

RecommendedMaintenanceSchedule(s)

MaintenanceServiceInterval

MaintenanceProcedure

•Checktheconditionofthedrivebelt.

Aftertherst8hours

•Checkthetensionofthestarter-generatorbelt.

•Changetheengineoil.

Aftertherst25hours

•Changetheengine-oillter.

Aftertherst50hours

•Adjusttheengine-valveclearance.

Aftertherst100hours•Performtheguidelinesforbreakinginanewmachine.

•Inspecttheseatbelt(s)forwear,cuts,andotherdamage.

Replacetheseatbelt(s)ifanycomponentdoesnotoperate

properly.

•Checkthetirepressure.

•Checktheengine-oillevel.

•Checkgear-shiftoperation.

•Checkthebrake-uidlevel.Checkthebrake-uidlevelbefore

yourststarttheengine.

Beforeeachuseordaily

•Washthemachine.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3439-467*A

PAGE 1
Form No. 3439-467 Rev A Workman® MDX Utility Vehicle Addendum If you have more than 1 machine, make a copy of this Addendum, and add it to your Operator's Manual(s). Access the latest Operator's Manual(s) for your machine at www.Toro.com.
PAGE 2
Recommended Maintenance Schedule(s) (cont'd.) • Grease the bearings and bushings. • Replace the air filter. Replace the air-filter element sooner if it dirty or damaged. • Change the engine oil. • Change the engine-oil filter. • Check the spark plugs. • Check the air filter for the carbon canister. • Check the condition of the tires and rims. Every 100 hours • Torque the wheel-lug nuts. • Inspect the steering and suspension for loose or damaged components. • Check the front wheel camber and toe-in.
PAGE 3
PAGE 4
Insert the following procedure into the Drive System Maintenance section of your Operator’s Manual. Inspecting the Steering and Suspension Components Service Interval: Every 100 hours—Inspect the steering and suspension for loose or damaged components. With the steering wheel at the centered position (Figure 1), turn the steering wheel to the left or right.