Addendum

ManualsBrandsToro ManualsMisc.Service Bulletins

FormNo.3439-468RevA

Workman

MDX-DUtilityVehicle

Addendum

Ifyouhavemorethan1machine,makeacopyofthisAddendum,andaddittoyourOperator'sManual(s).

AccessthelatestOperator'sManual(s)foryourmachineatwww.Toro.com.

AddthisAddendumtoyourOperator’sManualifyouhaveoneofthefollowingOperator’sManuals:

•3406-457(RevA)

•3411-880(RevA)

CrossouttheexistingRecommendedMaintenanceSchedule(s)tableinyourOperator'sManualandreplace

itwiththetableshownbelow.

RecommendedMaintenanceSchedule(s)

MaintenanceServiceInterval

MaintenanceProcedure

Aftertherst8hours•Checktheconditionofthedrivebelt.

•Changetheengineoil.

•Changetheengine-oillter.

Aftertherst50hours

•Adjusttheengine-valveclearance.

Aftertherst100hours•Performtheguidelinesforbreakinginanewmachine.

•Inspecttheseatbelt(s)forwear,cuts,andotherdamage.

Replacetheseatbelt(s)ifanycomponentdoesnotoperate

properly.

•Checkthetirepressure.

•Checktheengine-oillevel.

•Checkgear-shiftoperation.

•Inspecttheprimarydriveclutch.

•Checktheradiator-coolantlevel.

•Checkthebrake-uidlevel.Checkthebrake-uidlevelbefore

yourststarttheengine.

Beforeeachuseordaily

•Washthemachine.

•Greasethebearingsandbushings.

•Replacetheairlter.Replacetheair-lterelementsoonerifit

dirtyordamaged.

•Checktheconditionofthetiresandrims.

•Torquethewheel-lugnuts.

•Inspectthesteeringandsuspensionforlooseordamaged

components.

•Checkthefrontwheelcamberandtoe-in.

•Checkthetransaxle-uidlevel.

•Checktheoperationoftheneutralgear-shiftposition.

•Cleantheengine-coolingareas.

Every100hours

•Inspectthebrakes.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3439-468*A

Summary of content (4 pages)

PAGE 1
Form No. 3439-468 Rev A Workman® MDX-D Utility Vehicle Addendum If you have more than 1 machine, make a copy of this Addendum, and add it to your Operator's Manual(s). Access the latest Operator's Manual(s) for your machine at www.Toro.com.
PAGE 2
Recommended Maintenance Schedule(s) (cont'd.) • Change the engine oil (twice as often in special operating conditions; refer to Maintaining the Machine under Special Operating Conditions. Every 150 hours • Change the engine-oil filter. Change the oil twice as often during special operating conditions. • Clean the primary drive clutch (more often in dusty or dirty conditions). • Adjust the parking brake, if needed. Every 200 hours • Check the condition and tension of the drive belt.
PAGE 3
PAGE 4
Insert the following procedure into the Drive System Maintenance section of your Operator’s Manual. Inspecting the Steering and Suspension Components Service Interval: Every 100 hours—Inspect the steering and suspension for loose or damaged components. With the steering wheel at the centered position (Figure 1), turn the steering wheel to the left or right.