Outdoor Timer User Manual

PGM A

1 2 3 4 5 6

3 5

Turn the control dial to the

set zone times

position.

Check the programs switch setting. If necessary,

reposition the switch to select the desired program.

Zone number 1 will be flashing and its current run

time or OFF will be shown. To select a different zone

number, press the +/on or –/off button until the

desired zone number is flashing.

Press the next button. The run time (or OFF) will

begin flashing.

To set the run time, press the +/on or –/off button

until the desired run time is shown.

Note: To remove the run time, select OFF by press-

ing the +/on and –/off buttons at the same time.

Press the next button. The next zone number will

begin flashing.

7. Repeat steps and

as needed to set, change, or

remove the run time for the remaining zones

8. To set the zone run time for another program, repeat

all of the steps starting at step .

Return the control dial to the

run position.

Note: Basic programming is now complete.

If the ECXTRA is controlling a water supply pump,

continue at “Pump Control” on page 29 for important

operating information.

Setting Zone Run Times

3 5