Outdoor Timer User Manual

Once programmed, the ECXTRA memory will be
retained for several years with or without power. Only
the current time and date information will be lost and will
need to be reset if power is disconnected for more than
24 hours.
The programmable memory can be cleared and reset to
the default settings of individual programs or all pro-
grams simultaneously. (Refer the the default settings
listed on page 21.)
IMPORTANT: This procedure permanently erases the pro-
grammable watering information and can not be automati-
cally restored once the procedure has been completed.
To clear the memory of a selected program (Example 1):
Turn the control dial to the season adjust
position.
Check the programs switch setting. If necessary,
reposition the switch to select the desired program.
Press the next button to access the clear memory
feature; CL will be displayed and begin flashing.
Press and hold the –/off button until CL stops
flashing (approximately five seconds). The memory
will be cleared to the default settings.
5. To clear the memory of another program, repeat all
of the steps starting at step .
Return the control dial to the run position.
To clear the memory of all programs (Example 2):
Turn the control dial to the off position.
Press the next button to access the clear memory
feature; CL will be displayed and begin flashing.
Press and hold the –/off button until CL stops
flashing (approximately five seconds). The memory
will be cleared to the default settings.
Return the control dial to the run position.
Service and Specifications
Clearing the Program Memory
36
Example 1
Example 2