Outdoor Timer User Manual

Timer Installation

Note: The ECXTRA indoor timer is not weather resis-

tant and must be installed indoors or in a protected

area.

Indoor Model Installation

1. Select a location for the timer within 4′ (1,2m) of an

electrical outlet to enable the transformer cord to

easily reach. Make sure the outlet is not controlled

by a light switch or used to power any large appliance

such as a refrigerator, freezer, or air conditioner.

2. Remove the mounting bracket attached to the back

of the timer housing by pulling the lower edge of the

bracket away and downward from the timer housing.

3. Place the mounting bracket (A) against the wall

aligning the top edge at about eye level. Drive two

stainless steel screws (B) into the wall through two

holes provided in the bracket. For additional stability,

secure the bracket with three screws.

Note

: If you are installing the bracket on drywall or

masonry, install screw anchors (C) to prevent screws

from loosening.

Optional - Insert 3/4″ (19mm) PVC conduit (D) for

valve wiring into bracket sleeve (E).

5. Align the slotted openings on the back of timer hous

ing with the mounting bracket tabs. Slide the timer

downward to engage the tabs.

Note: After installation, store the Quick Start Guide in

the pocket (F) formed between the timer and bracket.