Accessory Guide
Workman
®
HD Series Accessories
Accessory Options
Automatic Tailgate Release
|
92-1220
• Automatic tailgate release when dumping
from cargo bed and resets automatically upon
lowering bed
• Saves operator time and effort as they do not
need to leave their seat to dump cargo
• Works on full or 2/3 full bed with full sides
Note: Does not work with Folding Side Kit
Hand Throttle HDX-D
|
07420
• Mechanical throttle and speed limit control
• Provides constant RPM for stationary attach-
ments or a controlled maximum speed for
applications such as spraying or spreading
Hand Throttle Kubota
®
EFI
|
07388
• Electronically-controlled throttle and speed
control
• Holds RPM constant during spraying and
topdressing applications for consistent
application rate
Rear PTO Kit
|
07419
• Rear-mounted, 540 RPM, PTO shaft mechanically
driven by transaxle
• Required for the Workman Sprayer System - 41235
Rear PTO Overrunning
Clutch Kit
|
92-2655
• Required when using rear mounted, high intertia
attachments, such as mower decks or blowers
• Allows the attachment drive shaft to continue
rotating after disengagement of the vehicle PTO
Spark Arrestor
|
112-1688
• Used for Daihatsu engines
• Fits into end of tailpipe to help prevent sparks
from emitting from exhaust
Side-Mounted Rear View
Mirror Kit
|
115 -7849
• 8 ½” (21.6cm) convex mirror with mounting
capability on either side of the operator or
passenger side of the vehicle
Plastic Bedliner
|
07331
• A rugged, weatherproof plastic construction liner
that protects cargo bed
2” Receiver Hitch Kit
|
117- 4831
• Provides a 2” (5cm) square receiver to enable
a “drawbar” hitch
High Air Intake Kit
|
121- 6285
• Kit extends air intake system from underneath
the cargo bed to a position slightly above the
ROPS shield behind the passenger position of the
vehicle
• Recommended for dusty applications
Trailer Brakes
|
117- 4837
• Kit provides a controller which plugs into
Workman vehicle and a positive wire
• Assists the hook up of customer supplied electric
trailer brakes
Trailer Signal Wiring
|
117- 4836
• Kit provides electrical wire for Workman vehicle
• Allows operator to enable easy hook up to
customer supplied trailer signal and brake lights
Reverse Alarm
|
107-8037
• Provides automatic reversing alarm
• Sounds whenever the vehicle is in reverse gear
Mid-Mount Kit for Vertical Lift
|
93-3741
• Specific mounting kit required for installation
of 1/3 vertical lift in the mid position of the
vehicle frame
Rear 1/3 Area Mounting Kit
|
93-9249
• Specific mounting kit required for installation of
1/3 Flatbed in rear position of the vehicle frame
Engine Cover Kit
|
117- 4867
• Shield device that covers alternator and belt on
liquid-cooled models
Note: Not available for air-cooled models
Remote Hydraulic Manifold Kit
|
110-2626
• A hydraulic manifold kit that provides the
ability to switch hydraulics between cargo bed
actuation and remote port usage via use of an
operator panel-mounted switch
Horn Kit
|
115 -7825
• Used to alert other vehicles, pedestrians or traffic
Tachometer/
Speedometer for HD
|
115 -7786
• Provides a tachometer and speedometer for the
HD air-cooled Workman
Remote Hydraulic Float Kit
|
117- 4828
• A hydraulic float kit that enables both hydraulic
lifting and the “float” down position
• Required when a Deere TC125 is used