Data Sheet

The Toro Company
Micro-Irrigation Business
1588 N. Marshall Avenue, El Cajon, CA 92020-1523, USA
Tel: [phone] or [phone]
Fax: [phone] or [phone]
www.toromicroirrigation.com
ALT158 09/10
The Xpando Take-Off is installed by first
inserting the grommet into PVC or HDPE pipe,
t
hen inserting the collapsing barb into the
Grommet. As the barb enters it collapses inward
eliminating grommet damage.
Procedure
• Drill hole in PVC or HDPE pipe to the appropriate sized as per Installation Specification table.
• Clean burrs from edge of hole before inserting Grommet.
• Push Xpando adapter into grommet ensuring flange finishes flush with top of grommet.
Lubricate with water to aid insertion.
• Install further connections to adapter using appropriately sized LDPE tube.
Tape Risor Assembly Details
Materials
Installation
Xpando
®
Take-Off
Installation
Xpando is a registered
trademark of the Antelco
Corporation
ADAPTOR MATERIAL
Xpando Adapters: all sizes Acetal
Rubber grommets: all sizes Thermoplastic rubber
STEP 1 STEP 2 STEP 3
Drill hole to recommended hole
size. Use low speed drill. Remove
burrs from hole.
Place appropriate grommet firmly
in hole with flange facing out.
Push Xpando take-off adaptor into
grommet until flange and
grommet are flush.
LDPE
tube
Xpando
®
Adaptor
Grommet
Tape Hose Xpando Grommet Wire Tie Min. PVC ID Hole Size*
5/8" EHD1350 XP-13x13 CAP-13 6" 1 1/2" 5/8"
7/8" EHD1850 XP-16x18 CAP-16 7" 2" 3/4"
1" EHO2055 XP-19x21 CAP-19 8" 2" 7/8"
*Hose size and drill bit size are the
same use forstner or step drill bit
Tee
HDPE or PVC pipe