Installation Guide

11
www.homewerksww.com
EXISTING CONSTRUCTION ASSEMBLY INSTRUCTIONS – ATTIC SPACE NOT ACCESIBLE
1
1. Remove existing fan.
2. Measure the opening to ensure it is large
enough to accommodate the new fan housing
(7-1/2 in. x 7-1/4 in.).
3. If this fan is not replacing an old fan, be sure
to cut a 7-1/2 in. x 7-1/4 in. opening for the
fan housing (A).
1. Choose which nial nish suits your application.
Place rubber spacer (BB) on the LED light kit
threaded rod. Then place the glass globe on to
the rod. Finally place the chosen nial on the
rod and tighten into place with the matching
nial nut.
Hardware Used
BB
Rubber spacer x 1
NOTE: Glass globe should not be mounted less
than 2.0 cm from the ceiling board.
2
3
9.4"
9.4"
7-1/4 in.
7-1/2 in.
INSTALLING LED LIGHT KIT AND GLASS GLOBE
2
BB