Installation Guide

3. If this fan is not replacing an old fan, be sure

to cut a 7-1/2 in. x 7-1/4 in. opening for the

fan housing.

4. Place the fan housing (A) next to a ceiling joist

or wall stud. The fan housing should be level

and perpendicular to the joist or stud. Allow for

thickness of ceiling board used in your applica-

tion. DO NOT ush mount to joist. Bottom of fan

housing (A) should be ush with ceiling board.

5. If needed before mounting the fan housing to

the joist, remove the plastic duct connector for

easier access to the mounting hole on the fan

body.

Remove the duct connector by inserting a at

head screw driver between the plastic and metal

of the housing, then GENTLY pry the duct

connector off.

6. Mount fan body to the joist or stud using long

wood screws (AA) where indicated by arrows

outside fan housing (A).

Hardware Used

Long wood screws x 2

9.4"

7-1/4 in.

7-1/2 in.

EXISTING CONSTRUCTION ASSEMBLY INSTRUCTIONS