User's Manual

APPLICANT: TOSHIBA CORPORATION TRANSCEIVER TYPE: CJ6DCE49203A
PAGE 5 OF EXHIBIT Type
“
User Manual
”
3. OPERATION
3-1 BASIC OPERATION
Turning the Unit On
Press the switch. The indicator will light (all indicators will light momentarily and then shows your
Telephone Number, and a Tone will be heard).
Note: To turn the Unit OFF, press
again for about one second.
* Signal Strength Indicator
This enables you to know the Signal Strength in your Area.
The number of the shaded blocks indicates it, and four blocks is the maximum level. The display will vary
as your car moves. If the signal is not strong enough to originate a call, “No Service” will appear on the
Dot display and also “No Service Indicator” will lit on.
To Store a Number in Memory
1. Press then enter a Telephone Number.
2. Press
, , then enter the Memory Address
(01 through 99).
To Recall a Number from Memory
Press , the display shows “Address” then enter the Memory Address (01 through 99).
Phone Book Scroll
This feature will be useful in finding a certain Telephone Number by scrolling the Repertory Memory
Addresses
1. Press , enter the memory address (01 through 99)
2. Press
or
: Previous Address
: Next Address
Automatic Number Entry
This feature allows an automatic Number Entry into the vacant Repertory Memory Address.
1. Enter a Telephone Number.
2. Press
, , , .
If there is no vacant Address in the assigned Area, Telephone Number will remain not entered in the
Memory.
To Lock the Unit
Press , , .
The Unit will remain locked until unlocked, even if the power is turned off.
To Unlock the Unit
Enter the 4 digit unlock Code. The “LOCK” will go out when the Unit is unlocked.