User Manual

90
? MESSAGES
Q
“Password =” is displayed.
A
The password is registered.
Input the password that was registered with [Toshiba HW Setup] and press the Enter
key.
If you do not remember the password, use the key floppy disk. If you do not have the key
floppy disk, check the model of your computer and contact the nearest maintenance service.
A request to the maintenance service because of a deleted password requires submission of
your identification and a service fee will be charged.
REFERENCE: See “Chapter 4.3 Passwords” for information about entering the password.
Q
“The input password is not correct.” is displayed.
A
You may have input the password in the wrong case because the input mode was
inappropriate.
Press the Shift
+ Caps Lock Alphanumeric keys to select the appropriate input mode and
input the password again.
Q
“Previous resume from hibernate failed. Would you like to tray again
[Enter = Y, Esc = N]?” is displayed.
A
Hibernate mode is disabled.
You cannot restore the previous state of your computer once you turn off your computer.
Press the Enter
key. If the same message is displayed again, press the Esc key.
Q
The following messages are displayed.
• “Remove disks or other medias. Press any key to restart.”
• “Non-System disk or disk error. Replace and press any key when ready.”
• “Invalid system disk. Replace the disk, and then press any key.”
• “Boot: Couldn't Find NTLDR. Please insert another disk.”
• “Disk I/O error. Replace the disk, and then press any key.”
• “Cannot load DOS, press any key to retry.”
A
If your computer has an optional floppy disk drive connected, remove the floppy disk from
the floppy disk drive and press any key.
A
Check “Trouble Checklist” provided at the end of this manual and contact Toshiba PC Dial.