User's Manual
Table Of Contents
- Copyright
- Disclaimer
- Trademarks
- FCC information
- EU Declaration of Comformity
- VCCI Class B Information
- Canadian regulatory information (Canada only)
- Following information is only for EU-member states:
- Table of Contents
- Preface
- General Precautions
- Chapter 1
- Chapter 2
- Chapter 3
- Chapter 4
- Chapter 5
- Chapter 6
- Chapter 7
- Chapter 8
- Chapter 9
- Chapter 10
- Appendix A
- Appendix B
- Appendix C
- Appendix D
User’s Manual 6-11
Power and Power-up Modes
To install a battery, follow the steps as detailed below:
1. Insert the battery pack as far as it will go into the computer (1).
2. Ensure that the battery pack is securely in place and the battery safety
lock (2) is in its position.
1. Battery Pack
2. Battery safety lock
Figure 6-3 Securing the battery pack
3. Turn your computer over.
Starting the computer by password
If you have already registered a password, please enter the password
manually to start the computer:
To enter a password manually, follow these steps:
1. Turn on the power as described in Chapter 3, Getting Started. The
following message appears:
Username
2. Enter the Password.
3. Press Enter.
1
4
5
2
1
At this point, the hotkeys Fn + F1 to F9 do not work. They will function after
you enter the password.
If you enter the password incorrectly three consecutive times, the
computer shuts down. You must turn on the computer again and re-enter
the password.