User's Manual
Table Of Contents
- Copyright
- Disclaimer
- Trademarks
- FCC information
- EU Declaration of Comformity
- VCCI Class B Information
- Canadian regulatory information (Canada only)
- Following information is only for EU-member states:
- Table of Contents
- Preface
- General Precautions
- Chapter 1
- Chapter 2
- Chapter 3
- Chapter 4
- Chapter 5
- Chapter 6
- Chapter 7
- Chapter 8
- Chapter 9
- Chapter 10
- Appendix A
- Appendix B
- Appendix C
- Appendix D
User’s Manual 8-6
Optional Devices
5. Seat the RAM door in place and secure it with one screw.
1. RAM door
2. screw
Figure 8-3 Seating the memory module cover
6. Install the battery pack - refer to Replacing the battery pack section in
Chapter 6, Power and Power-up Modes, if required.
7. Turn your computer over.
8. Turn the computer on and make sure the added memory is recognized -
to confirmed it, Start
J
Control Panel
J
System and Maintenance
J
System icon.
Removing a memory module
To remove the memory module, follow the steps as detailed below:
1. Turn the computer off and remove all cables connected to the
computer.
■ Never allow metal objects, such as screws, staples and paper clips, to
enter the computer or keyboard. Foreign metal objects can create a
short circuit, which can cause computer damage and fire, possibly
resulting in serious injury.
■ Do not touch the connectors on the memory module or on the
computer. Debris on the connectors may cause memory access
problems.
Take care to ensure that the RAM door is firmly closed.
1
2