User's Manual
Table Of Contents
- Copyright
- Disclaimer
- Trademarks
- FCC information
- EU Declaration of Comformity
- VCCI Class B Information
- Canadian regulatory information (Canada only)
- Following information is only for EU-member states:
- Table of Contents
- Preface
- General Precautions
- Chapter 1
- Chapter 2
- Chapter 3
- Chapter 4
- Chapter 5
- Chapter 6
- Chapter 7
- Chapter 8
- Chapter 9
- Chapter 10
- Appendix A
- Appendix B
- Appendix C
- Appendix D
User’s Manual 8-7
Optional Devices
2. Turn the computer upside down and remove the battery pack (refer to
Chapter 6, Power and Power-up Modes.)
3. Remove one screw securing the RAM door.
4. Lift off the RAM door.
5. Push the latches outward and the memory module will pop up.
6. Grasp the memory module by the sides and pull it out.
7. Seat the RAM door in place and secure it with one screw.
8. Install the battery pack - refer to Replacing the battery pack section in
Chapter 6, Power and Power-up Modes, if required.
9. Turn your computer over.
Battery Packs
You can increase the portability of the computer with additional battery
packs so that, if you're away from an AC power source and your battery
runs low, you can replace it with a freshly charged battery. Please refer to
Chapter 6, Power and Power-up Modes for further information.
Universal AC Adaptor
If you frequently use your computer at more than one site, it may be
convenient to purchase an additional AC adaptor to be kept at each site in
order to remove the need to always carry the adaptor with you.
USB floppy diskette drive
The 3 1/2" external FDD drive module can be connected to the USB port.